PDA

View Full Version : Mossberg 500 trigger group...


hogdogs
July 6, 2008, 09:56 PM
Any of you guys experienced in the tear down/reassembly of the trigger group? I am proficient enough to do the work just need step by step guidline instruction and warnings to heed. If it looks to be too much for me when I read through it I will refrain. I am sure there is some sand in there as it was my dump truck back window gun and pick up gun for years...
Brent

Slopemeno
July 6, 2008, 10:40 PM
Spray some solvent in there, and blow it out with compressed air, then lube. You might even try the air alone. I found them to be a major PITA and not worth the effort to disassemble.

hogdogs
July 6, 2008, 11:56 PM
If they are a SEVERE PITA I may skip it... Heck I figure if I can do a 100% tear down/rebuild on those mini carburetors on 2 stroke equipment I could delve into this...
Brent