PDA

View Full Version : Ruger sight


MDS
June 30, 2008, 12:08 AM
I have a Ruger P-94. I want to put a new rear sight on it. I gave the old sight a couple of pretty good whacks. (yes I took the set screw out) Puppy would not budge. Anyone know any tricks?

gun44
June 30, 2008, 06:18 AM
Take a brass punch, and hammer, and tap the sight to get it to move! Be careful, because there is a Firing pin block plunger that protrudes through an opening under the sight, and it is under spring pressure, so don't lose it You may have to tap it pretty hard, if it is really stuck, and also try tapping from right to left. Also you may try some WD-40 on it prior to tapping.