PDA

View Full Version : Model 190 drawings/parts list needed


Buzzard 130
June 10, 2008, 02:02 PM
After digging out my old 1972 model Winchester 190 and running several rounds through it I discovered It has so much gunk inside it wants to jam. My buddy said to pull the pin and clean it. In doing so I seem to have broken either the end of the ejector or firing pin. It still fires but about every other round the brass gets hung up. Can anyone send me some drawings and take down procedures so I can get it fixed and prevent this again? I'm Confused!

Doyle
June 10, 2008, 03:18 PM
If you do a search on here, there is a very long thread about this rifle. Good luck.