View Full Version : Mossberg ATR 100 bipods.
May 22, 2008, 10:11 PM
who makes them? Or do most of you drill a swivel stud into the stock?
May 22, 2008, 10:21 PM
Most bipods either mount to a sling swivel stud (usually standard), a picatinny rail (AR Style) or the barrel (elcheapo style).
My advice: Install a sling swivel stud and either go with a Harris (best) or Rockmount (OK) bipod.
May 22, 2008, 10:30 PM
where would i get a stud that i know would fit the right bipod? or do the bipods come with them?
May 22, 2008, 10:50 PM
They're standard. If you buy a sling swivel stud mounted bipod it will fit your sling swivel stud.
You can pick up an uncle mike's sling swivel kit for your rifle from walmart. It's a very simple install if you have opposable thumbs and some basic tools (drill, center punch).
Walmart also sells a basic Rockmount bipod for about 40 bucks that isn't bad. Harris is better and lighter, but no problem with a Rockmount.
May 22, 2008, 11:00 PM
so all i need is this?
no extra bolts or screws, or anything like that?
May 22, 2008, 11:03 PM
That and a basic set of sling studs in your gun.
The bipod clamps onto the sling stud and the sling swivel then connects to the bipod.
May 22, 2008, 11:07 PM
can you link me to the hardware ill need? im not sure what exactly i need.
May 22, 2008, 11:20 PM
This set has wood screws for front and rear:
This set has wood screw for rear and machine screw/nut for forward (this is what I use, works with synthetics too. You epoxy in the rear wood screw on the synthetic stocks)
May 22, 2008, 11:26 PM
The Rock Mount (Wal Mart $39) fits on to the integrated sling mount just fine.
May 22, 2008, 11:27 PM
Oh if it has a sling mount already you should be good to go.
I was thinking the OP had a rifle with a bare stock (no studs/integrated mounts)
May 22, 2008, 11:31 PM
its this one.
May 22, 2008, 11:34 PM
You should be fine as is.
May 22, 2008, 11:37 PM
okay thank you.
vBulletin® v3.8.7, Copyright ©2000-2016, vBulletin Solutions, Inc.