PDA

View Full Version : stud removal in Win 67 and 67A


woodhead@pldi.net
February 26, 2008, 04:25 PM
How does the stud (not the stock screw) that holds the barrel to the stock come off. I have 67A barrel that someone (not me) put a grinder to the block and I do not know if it unscrews or is a wedge fit. Any written help or schemantics would be of great value. 2nd part, anyone know who can do a rechrome (nickel) to the bolts to these fine shooters? Thanks for any help, signed, Woodinski

Hawg Haggen
February 26, 2008, 06:13 PM
If there's no obvious dovetail it's probably soldered in. My ex wife has one but I don't remember details like that. I can probably take a look at it this wekend if you don't find out before then.

George R
February 26, 2008, 07:30 PM
The stud is a press fit, but why do you want to remove it? I can renickel the bolt, but I'm really backed up and not taking on any new work until the end of April.

George R
February 26, 2008, 07:44 PM
Answering my own question....you want to remove it because it was ground down and you want to replace it. duh.

woodhead@pldi.net
February 27, 2008, 11:47 PM
the schematics will help on the stud and the written part was educational--thanks again for the help--Woodinski