PDA

View Full Version : Bolt stuck on my remington 770


nicolaih
February 11, 2008, 03:14 AM
I just bought a remington 770 in 30-06. i took apart the bolt to clean it and when i reassemble it i could not get it to go back in to the rifle. i think i may have assembled it the wrong way becuase the firing pin is sticking out. i tried to take the bolt apart again but now it seems to be stuck. any help would be great!

Moloch
February 11, 2008, 04:19 AM
I dont own a Remmi 700 but as far as I know 99% of all bolt-action rifles need a charged firing pin to get the bolt back into the gun.

thallub
February 11, 2008, 08:45 AM
The striker head should be nearly flush with rear end of the cocking piece. If the striker head is not flush with the rear of the cocking piece it is because the striker head is resting in the big deep notch of the bolt body. Turn the cocking piece until the striker head is in the small notch. The bolt will now enter the receiver.

island66
February 11, 2008, 02:51 PM
Call Remington @ 800-243-9700. They can walk you through the process of recocking the firing pin.

nicolaih
February 11, 2008, 11:24 PM
i tried turning the cocking piece but it will not move does anyone know how to to that?

Moloch
February 12, 2008, 03:41 AM
Bring the bolt and the rifle to a gunsmith, there is obviously something wrong wich may hard to fix.

island66
February 12, 2008, 08:33 AM
Trust me...there's nothing wrong with your bolt other than the fact that the firing pin is in the fired position. The guys @ Remington can help you out. Call them.

jeo556
February 12, 2008, 11:31 AM
Island 66 is wxactly right. Just call remington. I did the same thing but I didn't call remington. At least not at first, the whole episode ended in me breaking the bolt and needing to call Remington to order a new one...... At least the new bolt didn't have that stuid lock. :D

Jeo556