where can i find parts

[danwal123]

:):)Hi gang! I'm new to the forum places. But in googling for information, I landed here. So here goes. I have a Model 20 gauge that was purchased in Wal-Mart in the Mid 80's. The information I read on some prior threads have answered some of my ?'s.:D The gun is a Felix Sarasketa 20 gauge Model 70. I want to find out information on buying a new barrel. Here is all of the info on the gun.

On the barrel FELIX SARASKETA y.CIA.EIBER-SPAIN on the other side is
SAE INC MIAMI-FLORIDA MODEL 70.On the handle is R4512(I think this is the serial #). Also on the underside of the barrel is 20-76 FSC 1.100 kpcm 1380 15.9 z 2 and FSC 20-76 R4512 15.9 with 3 stars above it.

Any new information on this would greatly help. I would like to have a barrel with a smaller pattern. I think that this one is for skeet. I would like to use it for rabbit hunting.

We are here down south and the bunnies are good.

Any info of where to get parts or who sell these guns anymore, would be very helpful.

Thanks.

[ebutler462]

There was a gun made by Victor Sarasqueta of Eibar, Spain that was imported into the US from 1985-87. The spelling of the name is different. It may be the same gun as the Model 3 Boxlock. You might check with Numrich on their website about parts. Of course, you will probably need a good gunsmith to mate the barrels if you can find a set.

[J F Cooper]

Dan: I think you must mean Sarasqueta. There were three firms with the name Sarasqueta, making guns in Eibar Spain, in the mid 80s. They were Felix, J J and Victor Sarasueta, Unfortunately Felix made the lowest quality of the three.. I doubt they would fit a new barrel to your gun and I doubt you wold find a barrel for it.. The cost would be more than the gun is worth.. JF