PDA

View Full Version : Stripped swivel, need a solution to repair


superpelly
September 21, 2007, 08:55 AM
Whats the best way to repair a stripped swivel stud. Its the forearm thats stripped, the screw slips right out.

hoghunting
September 21, 2007, 12:34 PM
Depending on your stock, there is probably a nut for the swivel stud in the fore end. If you remove the barreled action from the stock, you'll see how the stud is attached. You can get the new stud and nut from Midway or your local gun shop.

DWARREN123
September 21, 2007, 04:48 PM
If no nut is present and it is just a hole in the wood/plastic there are epoxy glues that can be used to fill in the hole and it can be redrilled to accept the stud.
If it has a nut on/in the stock see if it is stripped if so it can be replaced.

superpelly
September 22, 2007, 06:03 PM
Thanks will take barrel off. I think its stripped, no nut will check.

superpelly
September 22, 2007, 07:56 PM
No nut, will fill the hole with some type of epoxy?

T. O'Heir
September 22, 2007, 08:01 PM
Yep. Fill the hole with epoxy, bedding material is best, and re-drill. Put a piece of masking tape on the outside and fill from the inside. Reduces the amount of sanding required.

superpelly
September 23, 2007, 07:55 AM
Ah, nice tip.
Thanks

superpelly
September 25, 2007, 03:51 PM
Fixed it. Used some 2 part poxy. The swivel screw is well secured. Thanks :)