View Full Version : How do you remove the barrel from a Beretta Bobcat?
January 22, 2007, 06:06 PM
I have an aftermarket barrel I want to try. Do you just punch it out or is there another trick. I have only been able to get the pin to budge a little bit with a punch. What am I doing wrong? I don't what to pound to hard on that small aluminum frame.
January 22, 2007, 07:05 PM
The frame should be supported on a steel bench block, over a hole that is slightly larger than the pin. If the frame is not supported in this manner there is an excellent chance that you will break it. There is a good chance you will break it anyway, so be very careful!
January 22, 2007, 10:09 PM
Thr odds are you will break the frame. If I was still a gambling man I would give 5 to 1 odds the frame will crack. Sorry about that, I hope I'm wrong but I've seen several parts guns that some one tried to remove the barrel.
vBulletin® v3.8.7, Copyright ©2000-2014, vBulletin Solutions, Inc.