PDA

View Full Version : remington model 8 "stovepipeing"


jiminthecorner
July 27, 2006, 08:46 AM
Hope this is the right place. My model 8 is stove pipeing rounds. The first two are fine but then they won;t eject properly . Any body out there have a solution?? Its in 35 remington and was my Dad,s Favourite for deer up here.:confused:

Doubletaptap
July 29, 2006, 11:18 PM
First thing is to spray some CLP around and under the extractor if you can. To get any build up of crud from beneath it. Use the little red tube so it kinda blasts down in there. WD-40 will tell you if it's going to work or not.
Then try it and see how it works.
I'd say next is check the edge and see if it still has a good gripping surface or if it's worn down quite a bit. Could be about time for a replacement.
Check the spring if it has one. Could be weak.
Could be a little bent also.
Jope that helps a little.
George

jiminthecorner
August 5, 2006, 08:08 PM
I need a new(used) extractor it seems. Now I have to find one!! Where do I look!! Jim:confused:

Dfariswheel
August 6, 2006, 01:09 AM
For parts:

Gun Parts Corporation is out.

http://www.jackfirstgun.com/ You have to call. Jack First is where most pros shop first.

http://www.poppertsgunparts.com/cgi-bin/webdata/webdata_gunparts.cgi
Poppert's list them as available.