PDA

View Full Version : Another question about Super Blackhawk sights


Jack Straw
September 1, 2000, 01:12 PM
In case you didn't read my other post about SBH sights, my dad's Old Model SBH has a messed up rear sight. Ruger's customer service was slightly less than helpful so I looked up the rear sight assembly in Brownell's. They list 2 sights for the SBH: one "with bump" and one "without bump"--both for the same price. What is the "bump" and how can I determine whether or not he needs the "bump"?

Thanks again

Jack

[This message has been edited by Jack Straw (edited September 01, 2000).]

George Stringer
September 2, 2000, 07:09 AM
Jack, remove the old sight and look at the bottom. That's were the bump is or isn't. George

Jack Straw
September 5, 2000, 09:39 AM
Thanks George.
Will do tonight.

Jack

po boy
September 5, 2000, 08:05 PM
ruger rear sights are JUNK the only complaint I have with ruger the Millet or Smith enterprizes are all steel and great only one pin to push out......