PDA

View Full Version : P220 barrel installation


rinoray
August 23, 2000, 08:49 PM
I have an older Sig P220 45acp. It currently has a pitted factory barrel and I want replace it. Sig charges $200 for a drop in factory barrel. Barsto charges $185 for a drop in and a gunsmith fit. I'm a reasonably competent machinist and have done several close tolerence projects (automotive engines). Am I nuts for thinking about fitting the barrel myself? A little dykem blue and very methodical steps to ensure lock up and timing. Should I call the Padded wagon now?
Thanks!

George Stringer
August 24, 2000, 07:04 AM
Rinoray, you're on the right track. Just take your time. Patience will be the most important asset for this job. George

Fred
August 24, 2000, 10:42 AM
Well, if you were the slightest bit technical, or knew something about cars, I'd say go ahead. But since you don't, send it to me and I'll fit it for you! :D :p

For you folks who might think I'm mean, we know each other, and rinoray has the skill to do this.

------------------
Regards - AZFred

rinoray
August 24, 2000, 07:20 PM
Fred,
You a funny man! When I'm out your way next time, I'll stop by and bring the slide, barrel, and Dykem blue. We don't have to talk about cars.
:D ;)
Regards,
rinoray