PDA

View Full Version : Disassembly of Kahr 9


Richard
July 20, 2000, 09:18 AM
When the moderator transfered this question here it didn't transfer. The answer is insure the weapon is unloaded. Retract the slide to the point the indicated in the manual. I think it is were the one end of the slide stop is just past the beginning of the barrel. Then take a small rubber or plastic hammer and knock the slide release loose. It is tricky but easilly done. Regards, Richard.

Mal H
July 20, 2000, 10:42 AM
Thanks Richard. I hadn't noticed that the thread failed to transfer completely. This software has been giving us fits lately.

Here's a link to ScottS' original question for others to read, if necessary.
[Link to invalid post]

George Stringer
July 20, 2000, 01:13 PM
Scott, I just sent you complete instructions via e-mail. George

ScottS
July 20, 2000, 10:09 PM
Thanks to:

Richard, for your quick response. I was looking for the detail strip instructions, but I appreciate your taking the time to help.

Mal, for moving the thread to somewhere it would generate a response.

George, for your excellent e-mail instructions.

Now, I can really get myself in trouble!

Scott