PDA

View Full Version : SP101 disassembly instrux


brionic
May 18, 2000, 06:57 PM
Can anyone point me to information regarding routine assembly/disassembly of an SP101? I'm trying to help a friend isolate a rattle which I believe is from a loose transfer bar.

I checked the owners manual but it doesn't provide anything other than scores of warnings and disclaimers.

Regards,
--
Brian

zot
May 18, 2000, 08:13 PM
I have 2 SPs and my manuals show where the
pin is in the inside of grips that when you cock the hammer you insert pin into hole on hammer bar, then pull trigger, thumb down the hammer as you pull the trigger, push hammer pin out ,pull hammer assembly out,
find the detent button on the inside of grip frame and push in and trigger assembly comes
out , cylnder assembly can be taken out too.
hope this helped

zot
May 18, 2000, 08:14 PM
try Strum Ruger,

zot
May 18, 2000, 08:15 PM
Sturm Ruger?

George Stringer
May 18, 2000, 10:12 PM
Brionic, the instructions are on the way. George

brionic
May 19, 2000, 04:58 PM
Thanks to you both, gentlemen. The instructions were most helpful!

Disassembly was a breeze, getting it all back together was a bit trickier... isn't always?

Anyway, I put in a call to SR re: the transfer bar, and the service rep told me that the jiggling is "nothing to worry about" since her handy .357 sample produces the same racket...

We'll see. Perhaps I give Keith Whaley a call!

Thanks again.

Regards,
--
Brian