front serrations

[choochboost]

If wanted to customize my slide with front serrations, where could I get it done?

[Harry Bonar]

Dear Shooter:
Find someone with a mill. If it is a standard size, mount it in a good vise with the adapter, set the head at 30 degrees, (head to the left , mtr. etc cutter to right) spacing is .070 per, measure back 1.400 to cut your first serration (3/8" cutter in R-8) come down .025 deep and start cutting from rear to front - cut 12 serrations, reverse slide and do same. It's done!


The "adapter" is what you mount the slide on horizontally which takes the "taper" out of the fix.
Harry B.