PDA

View Full Version : ruger m77 laminate stock question


Bert223
September 1, 2005, 02:53 PM
Hi,

I sanded out part of the barrel channel on my ruger m77 laminate stock and I was wondering if you guys could recommend a good finish to put in the barrel channel like laquer or stain or any other procedures that I should do to make the stock waterproof again? I appreciate any advice. As a side note the gun went from about 2 inch groups at 100 yards to about 5/8" groups just sanding down the front part of the barrel channel to make the barrel fully free floating.

cntryboy1289
September 2, 2005, 12:08 AM
Most any hardware supply should have a spar varnish. It might say spar urethane. I use it on barrel channels occasionally. I prefer to use Arrow's wood finish since it is a sealer, filler, and waterproof oil finish and I use it on the rest of the stock as well.

Bert223
September 2, 2005, 07:44 PM
Cool, thanks for the tip I'll give it a try.