PDA

View Full Version : sig p226 trigger pull


carbonm3
June 28, 2005, 10:33 AM
how does one actually shorten the trigger pull on a sig-sauer p226. i have a new all stainless 40 S&W and the trigger pull is too long in both single and double action.

signal4l
July 10, 2005, 09:23 AM
You may want to install a short trigger. Check www.sigforums.com for more info. Removing and reinstalling a trigger on a Sig pistol is a job for a gunmsmith/armorer.

DT Guy
July 10, 2005, 10:38 AM
One purchases a 1911, CZ SA or Browning HP.


:D :D :D :D



Larry

cntryboy1289
July 10, 2005, 05:09 PM
That was a good one there DT GUY. Seriously though, the Sigs seem to be very good firearms. I would suggest taking it to a smith and let him take care of this for you.

DT Guy
July 10, 2005, 09:41 PM
Seriously, I wouldn't hesitate to trust a SIG, based on reputation and the ones I've handled.

I just have never made friends with ANY crunchenticker.


I hear Langdon could do WONDERS with a SIG's trigger-I've dry-fired one he did, and it certainly was much better than stock. Too bad he stopped....


Larry