PDA

View Full Version : Ruger Takedown?


Parson Gun
February 17, 2005, 05:21 PM
Hello, folks
I just got a Ruger Security six, .357, stainless. I have done a lot of rifle work but I am fairly new to revolvers. Anyone know where I can get detailed takedown instructions, schematics, etc. for the Security Six?
Thanks
Parson Gun

Those who beat their swords into plowshares will be forced to plow for those who don't.

swinger_s87
February 17, 2005, 10:32 PM
Ruger has their manuals on the website, shows takedown as far as removing mainspring, hammer, trigger assembly, and cylinder. They also (i think so) have schematics in there that showed me everything i needed to see to work on mine. Good luck

cntryboy1289
February 18, 2005, 03:53 AM
Numrich should have a shcematic for the security six. As far as instructions goes, AGI has some good armorors tapes, they may have one for the security six. If not for it, for ruger revolvers.

Parson Gun
February 18, 2005, 01:41 PM
Thanks for the replies, that was very helpful. I am shooting that baby today!