PDA

View Full Version : Browning auto5 take down


alaskamaryann
December 28, 2004, 04:33 PM
Hi;
I would like to know the proper sequence and position for the bushing and brake on the magazine tube of a Browning auto5 depending on whether I'm using high or low brass.
If anyone can help it would be greatly appreciated.
Thanks Steve.

HankL
December 29, 2004, 08:20 AM
Hopefully this LINK (http://www.browning.com/faq/detail.asp?ID=105) will work. If not, the information you seek can be found on Browning's web site.
HTH

HunterTRW
December 29, 2004, 08:36 AM
The compression ring (with the concave inner surface toward the front) should be below the friction piece (which is mounted with its beveled edge toward the front of the tube), and both of these should be at the front of the recoil spring for medium-to-heavy loads. For light loads, reverse the compression ring and place it at the rear of the spring next to the receiver.

Good luck, and good shooting!

alaskamaryann
December 29, 2004, 09:10 AM
Thanks for the replies;
Exactly the info I was looking for.

Steve