PDA

View Full Version : Sks


astra9m
December 20, 2004, 11:17 AM
Hi, I know this is for full auto but I was woundering if anyone could answer my question. I have a chinese sks brand is norico i think and I got some 30 round mags for it but when you shoot it the front lip falls down am i doing something wrong. I Have two diferent brands and they both do the same thing.

2002gti
December 20, 2004, 12:24 PM
in an sks, i find stock configuration to be the best. get an AK if you want to rock and roll.......

3 weelin geezer
December 26, 2004, 11:20 AM
You wasted your money on those mags. I bought one for $20 and was all excited about bump firing the damn thing only to have it jam every shot because the lips were all wrong. Whats worse is that I left the original 10 rd mag at home and this aggravated me severely having to shoot it single shot. Then the recoil guide rod broke. Its been sitting around for 6 months waiting on parts. This is a NEW gun I might add. That mag is no more it has ceased to be courtesy of some slob leaving a car battery out in the desert. I shall never buy that garbage again! I do not buy something just to reengineer it to make it work.

wudjalike2no
December 26, 2004, 12:04 PM
make sure you push the front part up in there good, and if there is a problem with the lips just take a file/dremel to it

m0ntels
December 26, 2004, 08:55 PM
I got 3 30rd mag that work just fine as long as I make sure to load them with the rims stacked right and I just got a detatchable 10 rounder. The 10 tooka bit of work to get right but now it seems just fine. Had the bend the lips out a tad and squeeze the rounded part in the back for the follower in a bit to get it to fit in my reciever. When you first start trying to insert the mags it is a bit tricky because of the poor tolerences in all the parts and the fact that lip for the front is so damn small. As your mag gets worn in to your particular gun it should be alright.

Randy

jsflagstad
March 1, 2005, 10:45 AM
I have the composite 30 round mags in a Norinco and have yet to have a failure.

JSF :)