View Full Version : S&W SW9M help needed
December 28, 2002, 09:46 PM
My sister brings me a S&W SW9m 9mm pistol to clean for her. This is with out a doubt the cheapest looking piece of junk I have ever seen. Does anyone know how to disassemble this "pistol". It has no safety, slide release, nothing on the slide... what gives?
December 29, 2002, 03:40 AM
Remove the magazine and rack the slide, verify chamber is empty.
Point in a safe direction and pull the trigger.
Grip the slide and pull back about .5 inches.
There are two small tabs sticking out on either side of the frame, above the trigger. Pull both of these down at the same time. While holding them down, push the slide forward and it will come straight off the frame.
You can now remove the spring and barrel from the slide.
To put it together, reassemble slide, hold in front of frame, align rails, pull slide all of the way back (like chambering a round) and release.
December 29, 2002, 10:16 PM
THANK YOU! THANK YOU! THANK YOU!
vBulletin® v3.8.7, Copyright ©2000-2016, vBulletin Solutions, Inc.