PDA

View Full Version : Benelli Extended Choke/Muzzle Brake


Wolf226
August 6, 2002, 01:05 AM
Picked one of these up and it is too thick (OD about 3/4"0 to fit into my M1S90. I'm thinking it is for the M3.
Benelli doesn'yt have any info on this on their site.
Anyone know where I can get some info (part #, etc) on this unit?

Thanks in advance for any help...

hksigwalther
August 6, 2002, 11:37 AM
That muzzle brake comes stock on their M1Super90 Practical model. Essentially a long barrelled, long magged (10 rounds) M1. The muzzle is attached to a double threaded tube that fits in as a normal choke tube but extends out a treaded section the muzzle screws on to. The earlier version for the Practical had a muzzle that was much thinner, closer to the diameter of the barrel.

shootingbuff
August 9, 2002, 09:15 AM
So, can these be ordered w/ the adapter and mounted on any M1?

Thanks,

sb

hksigwalther
August 9, 2002, 09:56 AM
Should work on the regular screw-in choked M1s. I'm pretty sure the brake is made by Gunners Choice. They can be had through Brownells with the choke insert available in Cyl, Imp, Mod, and Ful. Also available for other makes than Benelli. I think the Practical's is Cyl but not totally sure, haven't measured it.

shootingbuff
August 9, 2002, 08:36 PM
Thanks much,

sb

UzziRider
August 11, 2002, 01:04 PM
To answer the original question, M3's are cyl bore and don't accept chokes...
And there are other manufacturers that make similar comp'd chockes for the M1S90. One that comes to mind is the "buck kicker" made by Kick's. http://www.kicks-ind.com/buckKicker.html