View Full Version : Field-strip on the Nomad?
June 7, 2002, 07:01 PM
Can anyone help?:)
June 7, 2002, 10:55 PM
I believe the Nomad is a version of the Buck Mark, in which case:
Remove the two screws holding the rear sight base. Use a good screwdriver and be careful not to lose the screws or the lock washers. Also, the screws are not the same, so save them carefully.
Remove the rear sight base and you can see the recoil spring and guide. Pull the slide back far enough to grasp the recoil spring guide at the front and ease it up and out of the slide.
Then lift the slide straight up and off the frame. That is the only stripping needed for cleaning. Reassemble in reverse order.
June 7, 2002, 11:12 PM
I've had a BuckMark before. Now that I look at it closer, that appears to be it.:)
June 8, 2002, 02:15 PM
That was pretty much the same. I think the front tenon screw on the sight base was staked on at one time, so I had to unscrew the barrel retention screw.
vBulletin® v3.8.7, Copyright ©2000-2017, vBulletin Solutions, Inc.