PDA

View Full Version : 10/22 bolt


tator
March 18, 2002, 01:37 PM
How do you remove the bolt from a 10/22? I accidently used a dah too much locktite on my scope base and I need to remove my bolt to clean everything out.

DAVID NANCARROW
March 18, 2002, 02:30 PM
Separate the action from the stock. Push out the two pins holding the trigger group from the receiver as well as the bolt stop pin located at the rear of the reciever and remove the trigger group. Invert the receiver, pull the charging handle back as far as it will go, and while holding the charging handle in the rear position, pull up on the front of the bolt and it will come out easily once it clears the bolt guide rails.