PDA

View Full Version : Changing out Ruger MKII Trigger HELP!


Hook_N_Bullet
February 13, 2002, 07:57 PM
I can't get the Dang Trigger Pivoy pin out! I'm afraid to tap too hard, but the sucker doesnt want to budge.

Anything I'm missing?

Hook_N_Bullet
February 13, 2002, 08:03 PM
Forget it! I grew some nuggets and smacked it a little harder; out she came!

Chris Orndorff
February 13, 2002, 09:22 PM
I'm not sure if the trigger pivot pin is so fitted, but some of the pins in the MkII have a "cannelure" around one end of the pin, into which fits a wire spring. Easier to lift the spring away from the pin and then push the pin out. Smacking it hard also works, but can damage the spring.

James K
February 14, 2002, 12:59 AM
The older guns used an inside "E" ring to retain the trigger pin. More than one frame was ruined by using a bigger hammer.

Jim

markmcj
February 14, 2002, 01:37 AM
That little spring is the killer in those pistols...... Never had alot of trouble with the mainspring housing........:D