any help

[starkey6]

Looking for a pair of rubber grips for a iver johnson top break 38 s&w. Just wondering if they make them or did make them or even wood ones woud work.

[James K]

If you mean repros of the original grips, try www.gungrip.com

Jim

[PetahW]

Vintage grips has them, but there are three sizes for .38 cal IJ revolvers, and it depends whether you revolver is hammerless or an exposed hammer type - you need to measure your gun and compare those to the measurements for each of the three grips.

The screws are not included, but Vintage Grips has them if you order them also.

http://vintagegungrips.net/ivjopigr.html

http://ep.yimg.com/ca/I/yhst-18204300343463_2241_1935889

http://vintagegungrips.net/ivjo38sw.html

Dimensions;
Measuring backside of right panel (vertical not diagonal) 2 17/32" long
1 1/8" wide across center of screw hole @ butt

http://vintagegungrips.net/ao-i2a.html

Dimensions / Sizes for the Iver Johnson .38 Break Top Revolver Grips.
Measuring right panel (vertical not diagonal)
2 7/16” @ longest point
1 1/8” wide across center of screw hole
1 5/32” wide across center of pin hole

http://vintagegungrips.net/ao-i2.html

Iver Johnson .38 Brk Top Rev. w/Hammer
Measuring back side of right panel (vertical not diagonal)
2 ½” long
1 1/32” between “ears” – tip to tip
1 1/8” wide across center of pin hole

.